16.4 Termcap Examples

Some examples:

termcap xterm*  xn:hs@

Informs screen that all terminals that begin with `xterm' have firm auto-margins that allow the last position on the screen to be updated (xn), but they don't really have a status line (no 'hs' - append `@' to turn entries off). Note that we assume `xn' for all terminal names that start with `vt', but only if you don't specify a termcap command for that terminal.

termcap vt*  xn
termcap vt102|vt220  Z0=\E[?3h:Z1=\E[?3l

Specifies the firm-margined `xn' capability for all terminals that begin with `vt', and the second line will also add the escape-sequences to switch into (Z0) and back out of (Z1) 132-character-per-line mode if this is a VT102 or VT220. (You must specify Z0 and Z1 in your termcap to use the width-changing commands.)

termcap vt100  ""  l0=PF1:l1=PF2:l2=PF3:l3=PF4

This leaves your vt100 termcap alone and adds the function key labels to each window's termcap entry.

termcap h19|z19  am@:im=\E@:ei=\EO  dc=\E[P

Takes a h19 or z19 termcap and turns off auto-margins (am@) and enables the insert mode (im) and end-insert (ei) capabilities (the `@' in the `im' string is after the `=', so it is part of the string). Having the `im' and `ei' definitions put into your terminal's termcap will cause screen to automatically advertise the character-insert capability in each window's termcap. Each window will also get the delete-character capability (dc) added to its termcap, which screen will translate into a line-update for the terminal (we're pretending it doesn't support character deletion).

If you would like to fully specify each window's termcap entry, you should instead set the $SCREENCAP variable prior to running screen. See section Virtual Terminal, for the details of the screen terminal emulation. See (termcap)Top section `Termcap' in The Termcap Manual, for more information on termcap definitions.

This document was generated on October, 2 2006 using texi2html 1.76.